Air conditioning service in Brunswick keeps split and ducted systems running efficiently through Melbourne summers and winters. Peak Air Conditioning Brunswick services reverse cycle split systems, multi-head systems and ducted air conditioning in the terraces, workers' cottages, postwar homes and new apartments of Merri-bek. Each visit follows a set checklist: filters cleaned, indoor and outdoor coils checked, drain lines flushed, refrigerant pressures read, electrical connections and controls tested, and the system run in cooling and heating to measure its performance. The technician leaves a written service report and prices any repair before work starts. Booking a service in spring, before the first hot spell, catches small faults early. Visits run from 6am to 10pm, seven days, with same-day appointments where possible.
GET A FREE QUOTE
12
Heating and cooling services
13
Brunswick and nearby suburbs covered
Free
Written quote before work starts
7 days
Open 6am to 10pm
Peak Air Conditioning Brunswick
A full service works through the same checklist on every visit, whatever the brand, so wear is caught while it is still small and cheap to put right.
The filters are removed, washed and dried, and the indoor coil is inspected for dust, lint and mould. The coil face and the outdoor condenser coil get a surface clean so air passes freely across them, and bent fins are combed straight. A coil that is heavily matted or mouldy needs a full wash with the unit bagged, which is a separate aircon cleaning job.
Condensate from the coil runs into a tray and out through a drain line. The tray is checked for slime and cracks, and the line is flushed to confirm water leaves freely, because a slow drain is what usually sends water down a wall in the middle of summer.
With the system running, gauges go on the service port to read operating pressures against the manufacturer's figures. Readings outside that range point to a leak or a restriction, and the finding is reported with a price rather than topped up on the spot, since leak finding and regassing are handled as an air conditioning repair. Connecting gauges counts as handling refrigerant, so it is done under an ARC refrigerant handling licence.
Terminals at the indoor and outdoor units are checked for tightness and heat marks, and the isolator switch is tested. The remote or wall controller is run through every mode, fan speed and timer setting, and the system's temperature sensors are compared with a reading taken by the technician.
Finally the system runs in cooling and then heating while the technician measures the air entering and leaving the indoor unit. That temperature difference shows whether the unit is moving heat as it should, and every reading goes onto the service report left with the owner.


Peak Air Conditioning Brunswick
A split system has two halves, an indoor head and an outdoor condenser, and each one wears in its own way.
On the indoor head, the front panel and filters come off, the coil face and blower wheel are checked for build-up, and the louvre motor is run through its full swing. The blower wheel is the long drum fan behind the louvres, and when it is dirty it flicks black specks onto walls and furniture. The mounting bracket and the seal around the wall penetration are checked as well.
The outdoor condenser is cleared of leaves, cobwebs and debris, and its coil is rinsed so heat can escape. Fan blades, the mounting feet or wall bracket and the pipe insulation are inspected, because insulation perished by sunlight lets the copper lines sweat and waste energy. Condensers squeezed into terrace side passages, courtyards and apartment balconies around Brunswick often have little room to breathe, so clearances are checked on every visit.
A multi-head system runs two or more indoor heads from one outdoor unit. Each head is serviced like a single split, then all heads are run together to confirm the outdoor unit keeps up and every room gets its share. One weak head on a shared outdoor unit can point to a pipe or valve issue that affects the whole circuit, so it is noted on the report.
Peak Air Conditioning Brunswick
Ducted air conditioning hides most of its parts in the roof space or under the floor, so a ducted service covers the whole air path, not just the indoor unit. Gas ducted heaters are a separate appliance with their own safety checks, covered on the ducted heating service and repairs page.
The return air grille, usually in a hallway ceiling, holds the filter that all the circulating air passes through. A clogged return air filter cuts airflow to every room and makes the unit work harder for the same result. The filter is cleaned or replaced, and the grille and its seal are checked so dust cannot bypass it.
Zoned systems use small motors to open and close dampers inside the ducts, so only the rooms in use get conditioned air. Each zone is switched on and off from the controller to confirm its damper moves and the airflow at the outlets changes. A stuck damper is a common reason one bedroom stays hot while the rest of the house is comfortable.
In the roof space, flexible ducts are checked for kinks, splits, crushing and joints that have pulled apart, all of which dump conditioned air into the ceiling. Outlets in each room are checked for airflow and loose diffusers, and the indoor unit's coil and drain are serviced much as on a split system. Older inner-north homes can have tight roof spaces, so access is confirmed when the job is booked.


Peak Air Conditioning Brunswick
No single interval suits every home, but a few factors decide how often a system needs a professional visit.
For most homes, one full service a year is the common recommendation, booked in spring before the first hot spell. A reverse cycle system that also heats through winter works hard all year, so some owners add a second visit before the heating season. Booking ahead of the summer rush also leaves time to fix anything the service turns up.
Systems that run most days, homes with dogs or cats, and houses close to traffic collect dust faster than average. Filters in homes along Sydney Road or near one of the many apartment building sites around Brunswick can clog well before the next booked service. In those homes, filters are worth checking monthly and a full service may be needed more than once a year.
Manufacturer warranty conditions often require regular servicing, so check the warranty document for the system to see what it asks for. Keeping each dated service report on file is a simple way to show the system has been maintained. For rental homes, Consumer Affairs Victoria requires gas and electrical safety checks every 2 years, which sit alongside routine air conditioner servicing rather than replacing it.
Peak Air Conditioning Brunswick
Peak Air Conditioning Brunswick services split and ducted systems across the inner north, including Daikin, Mitsubishi Electric, Fujitsu, Panasonic and other major brands. Gauge work on the refrigerant circuit is done under an ARC refrigerant handling licence, and service visits can be booked from 6am to 10pm, seven days, with same-day appointments where possible.
Every service ends with a written report rather than a verbal all clear. It records the condition of the filters, coils and drain, the refrigerant pressures and air temperatures measured, and any electrical issues found. Anything that needs fixing is listed with a price, and no repair goes ahead until the owner approves it. The report also gives a dated record to file with the warranty paperwork and to compare against at the next visit, so slow changes in performance are easy to spot.


Peak Air Conditioning Brunswick
The figures below are indicative Melbourne ranges from published cost guides, not fixed prices, and a written quote is given after inspection.
Melbourne cost guides put a split system service and clean at around $105 to $335 per unit, with about $210 typical (whatsthedamage.com.au, November 2026). The Quote Yard lists a single Melbourne split system service at about $140 to $230 (September 2026). Wall height, outdoor unit access and the condition of the coil all move the figure.
For a ducted system, the same Melbourne guide lists a service at about $210 to $580 per system, with around $345 typical. The Quote Yard puts a multi-zone ducted service at about $280 to $500. The number of zones, outlets and filters, and how easy the roof space is to reach, shape the final price.
Servicing every unit in one visit usually brings the cost per unit down, because the callout is only charged once. QuickAir lists a two to three head multi-unit service at around $280 to $480, and Climate Control Solutions adds about $80 to $120 for each extra head on a multi-head system. Some operators also add a separate callout of $60 to $100, so it pays to check whether a quoted price includes it.
Peak Air Conditioning Brunswick
Owners can handle some simple upkeep between services, which keeps airflow up and stretches the time before problems appear, but most of a service is technician work.
With the system switched off at the isolator, the washable filters in most split systems lift out from under the front panel. Vacuum off loose dust, rinse them in lukewarm water, let them dry fully in the shade and refit them, following the owner's manual for the model. Wiping the louvres, keeping plants and stored items clear of the outdoor unit, and vacuuming the ducted return air grille are also safe jobs. As a rough guide, checking filters every month or two in heavy-use periods is a good habit.
Anything behind the panels needs a professional: coil and blower cleaning, drain flushing, electrical checks and any work inside a roof space. Refrigerant work is restricted by law, because the Australian Refrigeration Council requires anyone who handles refrigerant or works on air conditioning equipment to hold a refrigerant handling licence. Spraying household cleaners into the coil or blower wheel can push grime deeper, wet the electronics and block the drain, so a badly soiled unit is better left to a technician.


A technician visits to look at the rooms, walls, roof space and outdoor unit position, checks the heating and cooling load, and provides a free written quote before any work starts.

The agreed work is carried out by refrigerant-licensed technicians, with pipe runs kept neat, drains fall-tested and any gas or electrical work done by licensed trades.

The system is pressure tested, commissioned and run in heating and cooling mode, then the controls, filters and manufacturer warranty requirements are explained at handover.
Melbourne cost guides put a split system service at around $105 to $335 per unit and a ducted system service at about $210 to $580 per system (whatsthedamage.com.au, November 2026). Where the price lands depends on the number of units, access to the outdoor unit or roof space and how dirty the system is. A written quote is given after inspection, and booking several units on one visit usually lowers the cost per unit.
Once a year is the common recommendation for most homes, ideally in spring before summer demand peaks. Systems used heavily all year, homes with pets and houses near busy roads may need servicing more often. Between visits, owners can check and clean the washable filters every month or two.
A full service covers filter cleaning, a check and surface clean of the indoor and outdoor coils, drain line and tray flushing, refrigerant pressure readings, electrical and controller checks, and a performance test in cooling and heating. On ducted systems it also covers the return air filter, zone dampers and duct runs. The findings go into a written report, with a price for any repair that is needed.
Manufacturer warranty conditions often require regular servicing, so check the warranty document for the specific system. Keeping dated service reports helps show the system has been maintained if a claim is ever made. The manufacturer warranty applies when the system is installed to the manufacturer's requirements, and a service does not change those terms.
As a rough guide, a single split system service commonly takes around an hour. A multi-head or ducted system takes longer, because there are more units, zones and duct runs to check. Hard-to-reach outdoor units and tight roof spaces also add time, so an expected duration is given when the visit is booked.
Owners can safely clean the washable filters, wipe the louvres and keep the outdoor unit clear, following the owner's manual. Work on the coils, drain, electrics or refrigerant needs a technician, and handling refrigerant legally requires a refrigerant handling licence from the Australian Refrigeration Council. A professional service once a year, with filter cleaning by the owner in between, keeps most split systems running well.
GET A FREE QUOTE
BUSINESS
SERVICES
OPERATING HOURS
Sun: 6:00am - 10:00pm
Mon: 6:00am - 10:00pm
Tue: 6:00am - 10:00pm
Wed: 6:00am - 10:00pm
Thu: 6:00am - 10:00pm
Fri: 6:00am - 10:00pm
Sat: 6:00am - 10:00pm