Ducted air conditioning in Brunswick heats and cools the whole house from one hidden indoor unit, with conditioned air delivered through insulated ducts to a vent in each room. Peak Air Conditioning Brunswick designs and installs reverse cycle ducted systems for Victorian and Edwardian terraces, interwar and postwar family homes and two-storey townhouses across Merri-bek and the inner north. Every system starts with a whole-home heat load calculation, with ducts and zones planned around the roof space or subfloor the house actually has. Brands such as Daikin, Mitsubishi Electric, Fujitsu and ActronAir are installed to the manufacturer's requirements by technicians holding an ARC refrigerant handling licence. Call for a written quote after inspection, with bookings from 6am to 10pm, seven days.
GET A FREE QUOTE
12
Heating and cooling services
13
Brunswick and nearby suburbs covered
Free
Written quote before work starts
7 days
Open 6am to 10pm
Peak Air Conditioning Brunswick
A ducted system has three parts: an indoor fan coil unit hidden in the roof or under the floor, an outdoor compressor unit, and a network of supply ducts ending in a vent in each room.
Most new ducted systems are reverse cycle, which makes them an all-electric ducted heating and cooling system in one. In winter the refrigerant flow reverses and the indoor coil becomes the heat source, so one system replaces both a gas ducted heater and wall-mounted coolers.
Ceiling vents are the standard choice for cooling, because cool air falls and spreads evenly through a room from above. Floor vents suit gas ducted heating, where warm air rises, but they cool poorly because cold air pools at floor level.
Where there is no usable roof space, a bulkhead unit sits inside a boxed-in section of ceiling, with short ducts to nearby rooms. Slimline ducted units are low-profile indoor units built for tight ceiling cavities and apartments.
An add-on cooling coil can be fitted to the existing gas heater with a new outdoor unit, so the same ducts deliver cooled air in summer. It only works well if the ducts are sound, properly insulated and served by ceiling outlets.


Peak Air Conditioning Brunswick
Zoning divides a ducted system into areas that motorised dampers inside the ducts open and close separately, so only the rooms in use are conditioned.
A single-storey home is often split into a living zone and a sleeping zone, so the bedrooms run overnight while the lounge and kitchen are switched off. A two-storey townhouse is usually zoned by floor, because heat rises and the upstairs bedrooms need more cooling than the ground floor.
A wall controller sets the mode, temperature, fan speed and which zones are open. Most current systems also offer Wi-Fi app control, so the house can be cooled on the way home from work.
Every ducted system draws air back to the indoor unit through a return air grille, usually in a hallway ceiling, and the system filter sits behind that grille. When zones close, a spill or bypass damper relieves the extra pressure so the remaining vents do not whistle and the fan is not strained.
Peak Air Conditioning Brunswick
Ducted air conditioning installation is a design job before it is a fitting job.
The technician measures every room and records ceiling height, insulation, glazing, window orientation and air leakage, then adds the loads together to size the whole system. A ducted unit is sized for the rooms that run at the same time, not simply the total floor area.
Each room's share of the load decides how much air it needs, and that sets the diameter of its duct, with larger trunk ducts feeding smaller branch ducts to each outlet. Runs are kept as short and straight as possible, because every sharp bend and sagging length of flexible duct adds resistance.
The indoor unit is hung from the roof framing on anti-vibration mounts, with a secondary safety tray underneath to catch any condensate overflow before it reaches the ceiling. The outdoor unit goes on a level slab or wall brackets with clear airflow, kept away from bedroom windows, and is linked to the indoor unit by insulated copper refrigerant lines. Larger systems may need a dedicated circuit or three-phase power, installed by a licensed electrician.
Refrigerant lines are pressure tested with nitrogen, evacuated with a vacuum pump and charged to the manufacturer's specification. The technician then measures airflow at each outlet, adjusts the zone balance and checks heating, cooling and drainage. At handover the owner is shown the controller, the zones and how to clean the filter.


Peak Air Conditioning Brunswick
Brunswick's mix of Victorian and Edwardian terraces, workers' cottages, interwar homes and newer townhouses decides where a ducted system can go.
Many Brunswick terraces have a shallow, low-pitched roof space behind the parapet, with little room to crawl and no space for a standard indoor unit. A slimline unit, a bulkhead in a rear room, or an indoor unit in the higher roof over a later rear extension are the usual answers.
Ducted air conditioning can run under the floor in homes with a timber floor and enough subfloor clearance, which is common in Brunswick's period and interwar houses. A horizontal indoor unit sits in the subfloor and the ducts feed floor outlets. Ducts are kept off the ground and sealed against moisture and vermin.
In a two-storey townhouse, the upper floor is usually served from the roof space and the ground floor through a bulkhead or ducts dropped through a cupboard or wall cavity. Some layouts use one smaller ducted system per floor, which keeps duct runs short and gives each level its own controller.
Peak Air Conditioning Brunswick
Peak Air Conditioning Brunswick designs every ducted system from measured data, so the quote reflects the house rather than a standard package.
An oversized ducted unit cycles on and off and leaves rooms clammy, while an undersized one runs flat out on the hottest days. The room-by-room load calculation sets the unit's kW capacity, the number of zones and the duct diameters before a price is given. The written quote names the units, outlets, zones and any electrical or gas work.
Refrigerant work is carried out under an ARC refrigerant handling licence, electrical work by a licensed electrician, and disconnecting an old gas ducted heater by a licensed gasfitter registered with the Building and Plumbing Commission. Once installed, the system can be kept running efficiently with a regular air conditioning service.


Peak Air Conditioning Brunswick
These are indicative ranges from published cost guides, not fixed prices, and a written quote is given after inspection.
National cost guides list a small home or apartment at around $5,000 to $8,000 installed, and a large multi-storey home at around $10,000 to $25,000 (hipages, March 2025).
For a three-bedroom house, or a single-storey four-bedroom house with good roof access, one Melbourne cost guide lists about $8,400 to $14,700, with $11,550 typical. Larger four-bedroom, two-storey or heavily zoned homes are listed at about $12,600 to $23,100, with $16,800 typical (whatsthedamage.com.au, November 2026). QuickAir gives a typical three to four bedroom outcome of $8,000 to $14,000.
The Victorian Energy Upgrades program estimates bill savings of up to $1,140 a year when a ducted gas heater is replaced with efficient reverse cycle. As a rough third-party guide built on assumed tariffs, one Melbourne estimate puts a year of heating for a well-insulated three-bedroom home at $300 to $550 with reverse cycle, against $700 to $1,100 with 5-star ducted gas (homeupkeep.com.au, June 2026). Running only the zones in use and keeping the return air filter clean both bring the bill down.
System capacity, the number of outlets and zones, roof or subfloor access, whether existing ducts can be reused, electrical upgrades and removal of an old gas heater all move the price. Replacing a ducted gas heater may also attract a Victorian Energy Upgrades discount, listed at up to $5,530 for a 22.4 kW ducted reverse cycle system, for approved products with a minimum five-year warranty.
Peak Air Conditioning Brunswick
Ducted is worth it when the whole house needs conditioning and the building can hide the equipment.
Ducted suits homes of three bedrooms or more, families who want every room at an even temperature and period homes where wall-mounted heads would clash with original cornices. It also makes sense when an ageing gas ducted heater is due for replacement, because the Victorian Energy Upgrades discount helps the numbers.
In an apartment, a small cottage or a home where only two or three rooms are used often, individual split system installation costs far less upfront. The wider comparison of system types sits under air conditioning installation.
A ducted system filters all the air it moves through one return air filter, which can be cleaned easily and upgraded to a finer grade on some models. A clogged filter cuts airflow and lets dust build up in the ducts, so it needs regular cleaning. Sealed duct joints stop dusty roof-space air being drawn into the system, and outlets and the return air path can be cleaned during a regular service. Households with asthma or allergies should ask about the filter grade at quote stage.


A technician visits to look at the rooms, walls, roof space and outdoor unit position, checks the heating and cooling load, and provides a free written quote before any work starts.

The agreed work is carried out by refrigerant-licensed technicians, with pipe runs kept neat, drains fall-tested and any gas or electrical work done by licensed trades.

The system is pressure tested, commissioned and run in heating and cooling mode, then the controls, filters and manufacturer warranty requirements are explained at handover.
A Melbourne cost guide lists ducted reverse cycle for a three-bedroom home, or a single-storey four-bedroom home with good roof access, at about $8,400 to $14,700. Larger, two-storey or zoned homes are listed at about $12,600 to $23,100. A written quote is given after inspection.
For a home of three or more bedrooms where most rooms are used daily, ducted usually is worth it, because one zoned system heats and cools the whole house. Replacing an old gas ducted heater can also attract a Victorian Energy Upgrades discount. In a small home or apartment, split systems are usually better value.
Yes, in homes with a timber floor and enough subfloor clearance, which suits many Brunswick period and interwar houses. A horizontal indoor unit sits in the subfloor and feeds floor outlets. Floor outlets heat very well but cool less evenly than ceiling vents.
It depends on how the house is used rather than a fixed number. A single-storey home commonly starts with a living zone and a sleeping zone, while a two-storey home is usually zoned by floor. The zone layout is set during the heat load design.
Ducted takes longer than a split system because the indoor unit, ducts, outlets and outdoor unit all have to be fitted. Most homes need more than one day, and two-storey homes, underfloor systems or gas heater removal can extend that. Peak Air Conditioning Brunswick sets out the expected timeframe in the written quote.
Yes. An add-on cooling coil and outdoor unit can be fitted to many existing gas ducted heaters so the same ducts deliver cooling. The ducts need to be in good condition and insulated, and ceiling outlets cool far better than floor outlets.
GET A FREE QUOTE
BUSINESS
SERVICES
OPERATING HOURS
Sun: 6:00am - 10:00pm
Mon: 6:00am - 10:00pm
Tue: 6:00am - 10:00pm
Wed: 6:00am - 10:00pm
Thu: 6:00am - 10:00pm
Fri: 6:00am - 10:00pm
Sat: 6:00am - 10:00pm